Ammasso 1100 Betriebsanweisung PDF herunterladen (Seite 15)

Enter the AMSO1100 install directory. This is where the commands, libraries,

and drivers will be installed.

Q2: Where would you like your config data stored?

[/usr/opt/ammasso/data/<hostname>]

This is where the rnic_cfg file for the Ammasso installation will be stored.

This file contains the network settings for the Ammasso adapter.

Q3: Would you like to configure interfaces of the Ammasso

1100 adapter? (y or n) [y]

If you have an rnic_cfg file from a previous installation, answer ‘n’ to

this question in order to retain that file. Answering 'y' allows you to

configure both of the IP addresses for the adapter, its network masks, gateway

addresses, etc. for this system.

At this point you have successfully installed the AMSO1100 package on your system. If you

are deploying the Ammasso software on many machines in a cluster, please see chapter 6 for

more details. The various commands, libraries, and drivers are installed in the directory

chosen in step 3.

The commands are linked into /usr/bin. The libraries are linked into /usr/lib or

/usr/lib64 as required. The man pages are linked into /usr/share/man. The startup

configuration script is copied into /etc/init.d and linked appropriately in

/etc/rc*.d. The Ammasso configuration file is copied into /etc/ammasso.conf .

NOTE: You must reboot your system for the drivers to be installed into the active

(running) kernel.

After you reboot, you can verify that that the drivers are loaded by using the ccons(8)

command to query the running firmware for the version number:

# ccons 0 vers

Cluster Core 1.2.1

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 65 66

Keine Kommentare

Ammasso 1100 Betriebsanweisung Seite 15